Lift system does not change the front track width of the vehicle.
Important Note: Will not fit Raptor models. Although rare, some models with 1-piece rear driveshaft may require rear driveshaft spacer kit to ensure sufficient spline engagement. This kit is offered with either 3" or 4" rear lift block kit and in either case it will replace the factory rear blocks. The 4" block will net a level to slightly tail high stance, the 3" block will net a level to slightly tail low stance. Choose rear lift height based on your ride height preference. If your vehicle is equipped with factory power steps, it will require E-Brake Relocation Bracket. Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration. Will not fit 7 lug applications.
Share
Fits these vehicles
1 vehicle listed by the manufacturer for this part.
Always confirm the fit for your exact trim before ordering — ask us if you are unsure.
