BDS 5" LIFT KIT WITH 3" REAR LIFT (5" BLOCK KIT) AND NX2 NITRO SHOCKS | 23-26 F-250/F-350 SUPER DUTY GAS WITH OVERLOAD SPRINGS
Easy, 100% Bolt-on installation.
Pro-Ride dual rate coil springs provide a remarkable ride through any terrain.
Heavy duty tubular steel radius arms that correct caster while maximizing ground clearance.
Track bar relocation bracket and pitman arm maintain proper steering angles for improved handling.
Fabricated steel blocks provide level stance from front to rear.
Important Note: Ford recommends the replacement of the pitman arm nut after each time it has been removed. Use a small pitman arm puller to remove the drag link joint and steering stabilizer taper. If your truck is equipped with a 2-piece rear driveshaft, a Carrier Bearing Drop Kit may be required: BDS-123402. Due to the taller factory ride height, Tremor models will not net full advertised lift height. Final ride height will be the same as standard models. Larger tires on stock wheel are not recommended due to interference with brake line, radius arm and sway bar. Minor trimming may be necessary for clearance of 37x12.50 tires on certain wheel setups. Installation requires a torque wrench capable of 406 ft-lbs. Trucks without top mounted overload springs will require (4) BDS-UBT4028. Fits SRW models only. Exhaust modification is required to clear the front driveshaft. The vehicle can be driven w/o a front driveshaf
Share
Fits these vehicles
2 vehicles listed by the manufacturer for this part.
Always confirm the fit for your exact trim before ordering — ask us if you are unsure.
